engineering fundamentals Discussion Forum
Directory | Career | News | Standards | Industrial | SpecSearch®
Home Membership Magazines Forum Search Member Calculators






List Recent Topics | Start a New Topic

<< Previous Message No. 11929 Next >>
Author: rorobert
Time: 08/21/03 11:47 PST
This is a reply to message no. 11908 by rolschwarz
Reply | Original Message | New Topic | List Topics | List Messages on This Topic
Current Topic:
geometric tolerancing
Thank you for your time. I have another GDT question regarding the axis of two cylinders. What call out would I use in a case that I want to be sure that the axis of two bores are parallel to each other? I do believe it is parallelism. The angle of the axis (axis on the same plane) cannot be more that a few degrees.
[ List Replies to This Message Only ]

Home  Membership  About Us  Privacy  Disclaimer  Contact  Advertise

Copyright © 2018 eFunda, Inc.