engineering fundamentals Discussion Forum
Directory | Career | News | Standards | Industrial | SpecSearch®
Home Membership Magazines Forum Search Member Calculators

Materials

Design

Processes

Units

Formulas

Math
List Recent Topics | Start a New Topic
 

<< Previous Message No. 11932 Next >>
Author: rorschach
Time: 08/21/03 12:28 PST
This is a reply to message no. 11901 by rorobert
Reply | Original Message | New Topic | List Topics | List Messages on This Topic
Current Topic:
geometric tolerancing
you should also check out efunda's section on GD&T:

http://www.efunda.com/DesignStandards/gdt/introduction.cfm
[ List Replies to This Message Only ]

Home  Membership  About Us  Privacy  Disclaimer  Contact  Advertise

Copyright © 2017 eFunda, Inc.