engineering fundamentals Discussion Forum
Directory | Career | News | Standards | Industrial | SpecSearch®
Home Membership Magazines Forum Search Member Calculators

Materials

Design

Processes

Units

Formulas

Math
List Recent Topics | Start a New Topic
 

<< Previous Message No. 11933 Next >>
Author: rorobert
Time: 08/21/03 13:15 PST
This is a reply to message no. 11930 by rorschach
Reply | Original Message | New Topic | List Topics | List Messages on This Topic
Current Topic:
geometric tolerancing
Thank you, that was very informative. I will go down and see if I can purchase that particular book. One other question.  How about if the bores axis' lie on the same plane and the axis of the two bores must be parallel, is that also a run-out tolerance?
[ List Replies to This Message Only ]

Home  Membership  About Us  Privacy  Disclaimer  Contact  Advertise

Copyright © 2017 eFunda, Inc.