engineering fundamentals Discussion Forum
Directory | Career | News | Standards | Industrial | SpecSearch®
Home Membership Magazines Forum Search Member Calculators

Materials

Design

Processes

Units

Formulas

Math
List Recent Topics | Start a New Topic
 

<< Previous Message No. 16263 Next >>
Author: acroduster1
Time: 06/04/05 21:47 PST
This is a reply to message no. 16233 by sdoughty11
Reply | Original Message | New Topic | List Topics | List Messages on This Topic
Current Topic:
Stresses in a clamped circular plate
Sam,

The traverse dimension refers to out-to-out measurements.  It only applies if you have a rectangular plate where the traverse dimension can vary if you measure it at different places.  In this case (a disk) it's the same dimension in all directions.
[ List Replies to This Message Only ]

Home  Membership  About Us  Privacy  Disclaimer  Contact  Advertise

Copyright © 2017 eFunda, Inc.