engineering fundamentals Discussion Forum
Directory | Career | News | Standards | Industrial | SpecSearch®
Home Membership Magazines Forum Search Member Calculators

Materials

Design

Processes

Units

Formulas

Math
List Recent Topics | Start a New Topic
 

<< Previous Message No. 22545 Next >>
Author: rek1
Time: 10/20/16 10:44 PST
This is a reply to message no. 22420 by MEMYMO24
Reply | Original Message | New Topic | List Topics | List Messages on This Topic
Current Topic:
Shaft with rigid coupling between two bearings

What is supporting the vertical shaft in position? Is there a thrust type bearing at the bottom of this shaft to support the hanging weight? Or a fixed bearing at the bottom? Since you are using a solid flange coupling, the shaft "acts" as if it is one solid piece. Expansion and contraction of the shaft with temperature changes might be problematic if the Delta T is enough and the shaft is long enough.

You should have a "fixed" bearing at the top nearest the sheave to support the weight of the shaft and also keep the drive and driven sheave aligned to minimize belt wear and sheave wear. That is, if you do NOT have a fixed or thrust bearing already mounted to the shaft elsewhare. If there is a thrust type bearing or a fixed type bearing mounted on this shaft elsewhere, the bearings on either side of the solid flange coupling can be expansion type. Self aligning bearings in pillow block or flange block type should be used. Flange type are easiest to mount and "center" in a vertical application.

[ List Replies to This Message Only ]

Home  Membership  About Us  Privacy  Disclaimer  Contact  Advertise

Copyright © 2017 eFunda, Inc.