Design Home Sensors Sensor Home Instruments/Devices Methods/Principles Displacement Stress & Strain Pressure Fluid Flow Flowmeter Introduction Categorization Selection Coriolis Differential Pressure Magnetic Positive Displacement Target Thermal Turbine Ultrasonic Transit Time Doppler Variable Area Vortex Temperature Resources Bibliography
Metal 3D Printing Design Guide

Direct Metal Laser Sintering (DMLS) 3D printing for parts with reduced cost and little waste.

Essentials of Manufacturing

Information, coverage of important developments and expert commentary in manufacturing.

Mechanical Engineers Outlook

Guide for those interested in becoming a mechanical engineer. Includes qualifications, pay, and job duties.

STEM Career Outlook

Wages, employment opportunities, and growth projections for STEM jobs.

more free publications
 Overview Turbine flowmeters, like windmills, utilize their angular velocity (rotation speed) to indicate the flow velocity. A good turbine flowmeter requires well designed and placed aerodynamic/hydrodynamic blades that are suitable for the fluid and flow condition and bearings that are both smooth and durable to survive the sustained high-speed rotation of the turbine.
 Further Information The cross section of a turbine looks like the following: To simplify the derivation of the formula, we assume that the blades of the turbine are straight and thin. The radius of the rotor (the radius at the roots of the blades) is a and the radius of the turbine (radius measured at the outer edges of the blades) is R, the width of of blades is c, and the distance between blades is S. The incoming flow with velocity V causes the turbine to rotate at angular velocity . If there is no velocity loss, the ideal angular velocity i can be related to the flow velocity V by a simple trigonometric formula where is the angle between the pipe axis (incoming flow direction) and the blades of the turbine, is the root-mean-square value of the inner and outer radii of blades to represent the average radius Now, instead of the ideal situation, the flow's velocity changes to VE after it passes the turbine blades, as shown in the above illustration. Because of this change of velocity vector, the flow applies a torque T to the turbine to make it rotate. The flow velocity V can then be related to the angular velocity of the turbine . Since the turbine is rotating at a constant speed, the above mentioned torque T must be counteracted by an equal amount of resistance torque. Neglecting all minor factors, the single most important contributor to this resistance torque is the sum of the drag force on each blade Fd where Cd is the drag coefficient, the ratio of the blade's drag to the drag of a perpendicular flat plate with equal area, and Re is Reynolds number. The torque T becomes where n is the number of blades. Using this expression, the to V ratio can be written as: The volume flow rate Q can then be expressed in terms of the angular velocity of the turbine In industrial applications, a K factor is commonly introduced to compensate for the neglected factors in the above analysis.
Common Specifications

Common specifications for commercially available turbine flowmeters are listed below:

Fluid Phase:

 Score Phase Condition Gas Clean Liquid Clean Liquid Corrosive Open Channel : Recommended : Limited applicability
Line Size: Inline models: 6 ~ 100 mm (0.25 ~ 4 inch)
Insertion models: 64 ~ 1500 mm (2.5 ~ 60 inch)
Turndown Ratio: 100 ~ 200 : 1
Pros and Cons

 • Pros: - Medium initial set up cost - Reliable, time tested proven technology • Cons: - For clean fluid only - Low to medium pressure drop
Glossary
Metal 3D Printing Design Guide

Direct Metal Laser Sintering (DMLS) 3D printing for parts with reduced cost and little waste.

Essentials of Manufacturing

Information, coverage of important developments and expert commentary in manufacturing.

Mechanical Engineers Outlook

Guide for those interested in becoming a mechanical engineer. Includes qualifications, pay, and job duties.

STEM Career Outlook

Wages, employment opportunities, and growth projections for STEM jobs.