Power Transmission

Gear drives, bearings, motors, clutches, couplings, machine controls, sensors and components.

Chemical Engineering

The industry gateway for chemical engineering and plant operations.

Autonomous Vehicle Engineering

The No. 1 media source for those developing the next generation mobility solutions.

Quality Magazine

Techniques to improve quality on the shop floor and in manufacturing planning.

more free magazines
List Recent Topics | Start a New Topic

Message No. 26435, Started by Veer Impex on 12/26/21

On a 36” pipeline, replacing a section 200 feet long.  Cold cut & remove the old section, drop in the new section which is a bit longer than necessary, do one weld, then how exactly is the other end measured?

With a sideboom, overlap the new section on one side of the old pipe, make a mark.

Swing it over to the other side, make a mark.

Put it on top of the old pipe, make a mark. 

Then take the shortest of those marks and that’s the final cut?

Or am I way off base here?

Reply | Start a New Topic | List Recent Topics
 

Follow-up Messages (1)
thanks https://shell-shockers.online
No. 26591, Posted by selenaoh123 on 04/18/22, 20:06 PST.
Glossary