Salary Expectation

8 things to know about the interview question "What's your salary expectation"?

Essentials of Manufacturing

Information, coverage of important developments and expert commentary in manufacturing.

Laser Focus World

Semiconductors, medical equipment, lasers, optics and aviation and aerospace.

3D Scanners

A white paper to assist in the evaluation of 3D scanning hardware solutions.

more free magazines
List Recent Topics | Start a New Topic

Message No. 26438, Started by mcneilinstruments on 12/26/21

I’m trying to drill a hole through a steel plate, approx 5mm thick, I’ve started with a smaller bit and then changed to a bigger one, this went through quite good, but, I need the hole to be slightly bigger, enough to get a 10mm bolt through. I therefore changed the bit to another, slightly bigger but when I try to drill into the hole the drill is literally bouncing off, I’ve given it a few goes but it continues to happen.
Any help where I’m going wrong would be greatly appreciated.

Reply | Start a New Topic | List Recent Topics
 

Follow-up Messages (2)
That's nice.
No. 26615, Posted by night_fury1212 on 05/10/22, 05:34 PST.
wow
No. 26598, Posted by oliversbrookss on 04/26/22, 16:23 PST.
Glossary